MSW GD2580-S Manual De Instrucciones página 34

4.3. Mounting vertical track
Vertical tracks (with seals) long with mounting
screws should be assembled as shown in figure 3:
Fig. 4
Note: Don't fully fasten the bolts; it will be more convenient for you to adjust the
position of the tracks.
4.4. Installation of vertical tracks
Arrange tracks as shown in figure 4. Determine the positions for screw tightening
according to the screw holes in tracks and attach the tracks as shown in figure 3 and 4.
4.5. Mounting horizontal tracks
Place the horizontal tracks along with fastenings on door tracks and screw them
together but do not fully tighten, figure 5.
66
seal
door track
vertical tracks
Fig 3
Rev. 20.11.2017
horizontal track flagangle
connective bend board
of horizontal track
After connecting horizontal tracks, please lift the horizontal track to keep their level
and fix them to the wall in accordance with Fig. 5 and 6.
According to the outside edge reference line of the left and right vertical track, use
a pencil to draw two parallel lines on the ceiling that are perpendicular to the front
wall. Locate the bracket assembling position in accordance with the perforated bracket
holes of the horizontal track.
Note: The two drawing lines must be parallel to each other and be perpendicular to
the front wall.
Make sure that the two perforated brackets are symmetrical and parallel, and the
connection bolts are fully tightened.
Note: Perforated bracket assembling is illustrated in Fig. 6.
level perfrated bracket
vertiveal perfrated bracket
sliding hold
Rev. 20.11.2017
horizontal track
Fig. 5
Fig. 6
67