MSW GD2580-S Manual De Instrucciones página 44

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 77
ERROR CODES
The display may show the following error codes:
"1.": faulty adjustment (setting) of garage door movement.
"2.": obstacle during garage door opening.
"3.": obstacle during garage door closing.
"4.": photocell covered or faulty.
"5.": error in learning or coding the remote controller.
"6.": operating time exceeded 100 seconds.
12.3. Wiring
Figure 37: Open the white lamp cover when wiring, find a row of wiring terminals
marked "PHOTO", use screw driver to connect wires in accordance with wiring
diagram shown in figure 37.
Note: Wiring should be professional. After finishing installation, the right and left lens
of photo beams should in the same line, and it must be remembered to activate the
function Photo beam in the opener, otherwise the photo beams will not function.
Fig. 37
86
12.4. DRIVE PROGRAMMING
GD2580-S, GD2375-S, GD3000-S, GD2500-I garage doors only and GD-600M garage openers only.
FUNCTION SETTINGS:
General view of control panel:
AUTOMATIC SETTING
Press and hold the "P" button until the display shows "A".
NOTE:
before activating the automatic setting make sure to install the mechanical limiter
for garage door opening at the drive track irrespective of the height of maximum
opening.
If the garage door features infrared sensor systems, make sure to first install these
infrared sensors before activating the automatic setting procedure. The sensors
must not be covered during automatic setting.
No one and nothing must disturb the operation of the drive during the procedure
of automatically setting – when performing the procedure do not let anyone stand
under the garage door or in its immediate vicinity, do not let anyone walk under
moving garage door.
Repeatedly press the "P" button to move between each individual setting of the drive
parameters. Use "+" and "-" buttons to set the desired value and "P" button to confirm
the setting and move to the next parameter.
Rev. 20.11.2017
Rev. 20.11.2017
As shown in the figure above the readiness status is
indicated by a flashing symbol "-", which indicates the
position in which the garage door currently is: symbol
"-" appearing at the top of the display indicates the open
position; appearing in the middle of the display indicates
position between the opening and closing position;
appearing at the bottom of the display indicates garage
door closing. During garage door movement the display
flashes showing the "-" symbol.
Press the + button, the lamp will start flashing and the drive will automatically
move the garage door to the open position, will stop the garage door in
its final open position then it will start closing the garage door until it is
fully closed. The lamp will start flashing to indicate that automatic setting
procedure is complete. The garage door is ready for regular use.
87

Publicidad

Tabla de contenido
loading

Tabla de contenido