Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
8. AIR CONDITIONER USE
1. DESCRIZIONE DEI COMPONENTI
8.7 Clock setting
Press the CLOCK key once; on the display will flash.
–
2 Within 5 seconds, press the
3 While the icon is flashing,
symbol
will stop flashing and the desired time will be set.
4 If the CLOCK button is not pressed again after setting the time
while
,is flashing, the set time will not be stored.
8.8 Timer scheduling
8.8.1 Programmed startup of the air conditioner
The TIMER can be set for any time of the day .
Press the TIMER key once.
will appear while
flashing symbol will disappear flashing.
O N
O F F
Set the desired hours and minutes by pressing the corresponding
+
keys.
Press the TIMER ON key to confirm the time setting for the
programmed startup.
The icon
will reappear and the symbol
this means that the
timer is active.
O N
O F F
To cancel the programmed startup, press the TIMER ON key several
times until the
symbol, and the section relating to the clock,
O N
O F F
disappear from the display..
The programmed startup time remains memorised; on each new
startup of the air conditioner, the
(see points 1 to 3) or cancelled (see point 4).
Attention!
The ambient temperature, the fan speed and the operating mode must be
set before the activation of the programmed startup
The TIMER ON operation must be performed with the unit turned off
8.8.2 Programmed shutdown of the air conditioner
The TIMER can be set at any time of day.
Press the TIMER OFF.
will appear while the flashing symbol
Set the desired hours and minutes by pressing the corresponding keys
Press the TIMER OFF button to confirm the set time for the
programmed shutdown.
The icon
will reappear and the symbol
means that the
timer is active.
O N
O F F
+
and
keys to set the current time.
press the CLOCK button again, the
B
A
B
A
B
A
B
A
will remain light,
O N
O F F
function can be reactivated
O N
O F F
B
A
.
O N
O F F
B
A
B
A
will disappear.
O N
O F F
- +
will remain light, this
O N
O F F
To deactivate the programmed shutdown, press the TIMER OFF
button 1 time until the symbol disappears from the display.
The programmed shutdown time remains stored each time the air
conditioner turns on. The function
1 and 3) or deactivated (see point 4).
B
A
Attention!
The ambient temperature, the fan speed and the operating mode must be
set before the activation of the programmed shutdown
-
OFF TIMER operation must be done on units turned off.
Nota:
When TIMER ON and TIMER OFF are both activated, both symbols will
light up
and
O N
O N
O F F
O F F
B
A
.
GB
GB
B
A
can be reactivated (see point
O N
O F F
B
A
B
A
.
O N
O F F
B
A
67
Publicidad
Tabla de contenido
