DigiTech RP1000 Manual De Instrucciones página 4

Warranty
DigiTech
®
We at are very proud of our products and back up each one we sell with the following
warranty:
1. The warranty registration card must be mailed within ten days after purchase date to validate this
warranty.
2. DigiTech warrants this product, when used solely within the U.S., to be free from defects in materials and workmanship
under normal use and service.
3. DigiTech liability under this warranty is limited to repairing or replacing defective materials that show evidence of defect,
provided the product is returned to DigiTech WITH RETURN AUTHORIZATION, where all parts and labor will be
covered up to a period of one year. A Return Authorization number may be obtained from DigiTech by telephone. The
company shall not be liable for any consequential damage as a result of the product's use in any circuit or assembly.
4. Proof-of-purchase is considered to be the burden of the consumer.
5. DigiTech reserves the right to make changes in design, or make additions to, or improvements upon this product without
incurring any obligation to install the same on products previously manufactured.
6. The consumer forfeits the benefits of this warranty if the product's main assembly is opened and tampered with by any-
one other than a certified DigiTech technician or, if the product is used with AC voltages outside of the range suggested
by the manufacturer.
7. The foregoing is in lieu of all other warranties, expressed or implied, and DigiTech neither assumes nor authorizes any
person to assume any obligation or liability in connection with the sale of this product. In no event shall DigiTech or
its dealers be liable for special or consequential damages or from any delay in the performance of this warranty due to
causes beyond their control.
NOTE: The information contained in this manual is subject to change at any time without notification. Some information
contained in this manual may also be inaccurate due to undocumented changes in the product or operating system since
this version of the manual was completed. The information contained in this version of the owner's manual supersedes all
previous versions.
Declaration of Conformity
Manufacturer's Name:
Manufacturer's Address:
declares that the product:
Product name:
Product option:
conforms to the following Product Specifications:
Safety:
EMC:
Supplementary Information:
The product herewith complies with the requirements of the Low Voltage Directive 2006/95/EC and the EMC
Directive 2004/108/EC.
European Contact:
DigiTech
8760 S. Sandy Parkway
Sandy, Utah 84070, USA
RP1000
all (requires Class II power adapter that conforms to the requirements of
EN60065, EN60742, or equivalent.)
IEC 60065 (7th ed. 2001)
EN 55013 (2001 + A1)
EN 55020 (1998)
Vice-President of Engineering
8760 S. Sandy Parkway
Sandy, Utah 84070, USA
Date: December 15, 2008
Your local DigiTech Sales and Service Office or
Harman Music Group
8760 South Sandy Parkway
Sandy, Utah 84070 USA
Ph: (801) 568-8800
Fax: (801) 568-7583