Troubleshooting - LAVAZZA SMEG Instrucciones De Uso

Problem encountered
Machine does not turn on.
Power lights are off after
having pressed the switch-
on/ supply buttons.
The machine requires a lot
of time to heat up.
The machine is very noisy.
No supply.

TROUBLESHOOTING

Possible causes
» Machine is not connected to
the power source.
» The machine is connect to
power strip not working.
» Power supply not present.
» Machine storage at low
temperatures
(e.g.: cellar/garage).
» The machine has limescale
build-up.
» Machine not is on a flat and
stable surface.
» Power supply cable
incorrectly positioned.
» Movable parts not fitted
properly.
» No water in the tank.
» Capsule not present.
» Electrical failure: buttons not
working.
» No water in the tank.
» Tank not inserted correctly.
» Power-on failed.
Solution
» Connected the machine to the power source.
» Connected the machine directly to the power
source.
» Connect another device to check the power supply.
» If the problem remain please contact L.C.S.*
» Store the coffee machine in a proper environment
and run 2 supplies without capsules.
» Descale the machine.
» If the problem remain please contact L.C.S.*
» Check the surface.
» Check the correct position of the cable into the
base of the machine.
» Fit the movable parts properly.
» Top up the tank with fresh drinking water.
» Insert Lavazza
A MODO MIO
compatible.
» If the problem remain please contact L.C.S.*
» Press one of the buttons and check the operation
of the pilot light (ON with white blinking light) and
the machine power-on.
» Top up the tank with fresh drinking water.
» Insert the tank correctly.
» Repeat the coffee machine power-on procedure.
» If the problem remain please contact L.C.S.*
35
EN
capsule or