Changing Tools; Setting The Mortise Depth - Festool DOMINO XL DF 700 EQ Manual De Instrucciones

DF 700 EQ
GB
when under load.
Temperature cut-out
The machine power supply is limited and the speed
reduced if the motor exceeds a certain tempera-
ture. The machine continues operating at reduced
power to allow the ventilator to cool the motor
quickly. If the machine temperature exceeds the
maximum permitted value for longer periods, the
machine switches off completely after approx. 40
seconds and can only be switched on again once the
motor has cooled sufficiently.
Restart protection
The integral restart protection prevents the ma-
chine from automatically starting up again after an
interruption in power when the machine is used in
continuous operating mode. In this case the ma-
chine must be switched off and then switched back
on again.
7.2

Changing tools

CAUTION
Hot and sharp tools
Risk of injury
Do not use insert tools that are blunt or defec-

tive.
Wear protective gloves.

Removing the tool
Lift the unlocking device [3-2] until it audibly

disengages using the open-ended spanner [3-
3] supplied (SW 12).
Separate the motor unit [3-5] from the guide

frame [3-4].
Press and hold the spindle lock [4-1].

Loosen the cutter [4-3] using the open-ended

spanner [4-2] and remove.
Release the spindle lock [4-1].

Inserting the tool
WARNING
Risk of injury
Before inserting a new cutter ensure that the

machine, the guide frame and the guides [3-1]
and [3-6] are clean.
Remove any contamination that may be present.

Only use sharp, undamaged and clean tools.

14
Press and hold the spindle lock [4-1].

Use the open-ended spanner [4-2] to screw on

the cutter [4-3].
Release the spindle lock [4-1].

Slide the guide frame [3-4] onto the motor unit

[3-5] until it audibly engages.
7.3

Setting the Mortise Depth

WARNING
Cutter can come out at the rear side of the work-
piece.
Risk of injury
Set the routing depth at least 5 mm less than the

workpiece thickness.
Press one or two snap buttons [1-8].

Set the slide for the routing depth setting [1-

7]to the desired routing depth (15 - 70 mm).
Release the snap buttons [1-8].

Check whether the slide [1-7] has engaged cor-

rectly.
 With the two markers [1-9], you can mark two
routing depths and switch easily between them
using the slide [1-7](e.g. for asymmetric DOMI-
NO dowel depth distribution).
7.4 Setting the Fence Height
 The alignment of the clamp levers [1-12] and
[1-14] can be aligned by raising the levers.
When tightened, the levers should not protrude
beyond the contact surface.
a) with selection slide
Loosen the clamp lever for the routing height

adjustment [5-1].
Using the front handle [5-2] raise the front part

of the guide frame.
Use the selection switch to set [5-6]the desired

routing height h (10 mm; 15 mm; 20 mm;
25 mm; 30 mm; 40 mm).
Press the front section of the guide frame down-

wards as far as the stop.
Close the clamp lever [5-1].

b) freely selectable
Loosen the clamp lever for the routing height

adjustment [5-1].
Using the front handle [5-2] raise the front sec-

tion of the guide frame.
Pull the selection slide [5-6] as far as the stop

in the direction of the motor unit.