Water Inlet - Zanussi ZWI 71000 WA Manual De Instrucciones

• After removing all the
packaging, carefully
lay the appliance on
it's back to remove
the polystyrene base
from the bottom.
• Remove the power
supply cable and the
draining hose from the
hose holders on the
rear of the appliance.
• Unscrew the three
bolts.
2
1
• Slide out the relevant
plastic spacers.
• Remove the polystyr-
ene block fitted on the
door seal. Pull out all
items from the drum.
• Fill the smaller upper
hole and the two large
ones with the plastic
plug caps supplied in
the bag with the User
Manual.
POSITIONNING
• Install the machine on a flat hard floor. Make
sure that air circulation around the appliance is
not impeded by carpets, rugs etc.
• Check that the machine does not touch the wall
or other kitchen units.
• If necessary, check the setting with a spirit level.
Any necessary adjustment can be made with a
spanner.
Never place cardboard, wood or
similar materials under the appliance
to compensate for any unevenness in
the floor.

WATER INLET

• The inlet hose is supplied with the appliance
and can been found inside the appliance drum.
• Do not use the hose from your previous
appliance to connect to the water supply.
This appliance must be connected toa
cold water supply.
45˚
35˚
• Set the hose correctly by loosening the ring nut.
After positioning the inlet hose, be sure to tight-
en the ring nut again to prevent leaks.
• Level the appliance by
raising or lowering the
feet.
• The feet may be tight
to adjust as they in-
corporate a self lock-
ing nut, but the appli-
ance MUST be level
and stable.
• After having levelled
the appliance, tighten
the lock nuts.
• Accurate levelling pre-
vents vibration, noise
and displacement of
the appliance during
operation.
• Connect the hose
with the angled con-
nection to the ma-
chine. Do not place
the inlet hose down-
wards.
• Angle the hose to the
left or right depending
on the position of your
water tap.
5