Weber Summit E/S-470 Guia Del Propietario página 29

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Burners
burn w ith a
yellow or orange
flame,
in
conjunction
with the smell of gas (This is norman
for the burner
lighting tube).
Symptoms:
Burner
does not light, or flame
is low in "Hi"
position.
PROBLEM
CHECK
Inspect Spider/insect
Screens for possible obstructions.
Clean Spider/Insect
Screens. (See Section "Annual
(Blockage
of holes.)
Maintenance")
Is fuel hose bent or kinked?
Straighten fuel hose.
Experiencing
flare-ups:
Does Burner light with a match?
Did you use the snap igniter several times until the main
burner lit (See Lighting Instructions)?
Does the igniter work (Do you see a spark when you
repeatedly
use the snap igniter?
Are you preheating
barbecue in the prescribed
manner?
Are the cooking grates and Flavorizer _ bars heavily
coated with burned-on
grease?
Is the bottom tray "dirty" and not allowing grease to flow
into catch pan?
CURE
If you can light Burner with a match, then check the
Crossovei _ ignition system.
Make sure to hold the control knob in for two seconds after
snapping the igniter and seeing the orange flame from the
burner lighting tube.
Try manually lighting the burner (refer to "Main Burner
Manual Lighting"). Call customer
service.
All burners on HI for 10 to 15 minutes for preheating.
Clean thoroughly.
(See Section "Cleaning")
Clean bottom tray.
CAUTION:
Do not
line
the bottom
tray
with aluminum
foil.
Burner
flame pattern is erratic.
Flame is low when
Are burners clean?
Clean burners. (See Section "Maintenance".)
burner
is on "HF. Flames
do not run the whom®
length of the burner
tube.
inside of lid appears
to be "peeNing."
(Resembles
The lid is porcelain enamel or stainless steel, not paint. It
Clean thoroughly.
(See Section "Cleaning".)
paint peening.)
cannot "peel". What you are seeing is baked on grease
that has turned to carbon and is flaking off.
THiS IS NOT A DEFECT.
Cabinet
doors
are not aligned.
Check the adjustment
pin on the bottom of each door.
Loosen adjustment
nut/s. Slide door/s until aligned. Tighten
nut.
mfprobmems cannot
be corrected
by using these methods,
pmease contact
the Customer
Service
Representative
in your area using the contact
information
on our web
site. Log onto www.weber.com
®.
PROBLEM
CHECK
CURE
Side Burner does not might.
Is gas supply off?
Turn supply on.
Flame is low in "HI" position
Is the fuel hose bent or kinked?
Straighten
hose.
Push button
ignition does not work.
Does burner light with a match?
If match lights burner, check igniter (see below).
if problems
cannot
be corrected
by using these
methods,
please contact
the Customer
Service
Representative
in your area using the contact
information
on our web
site. Log onto www.weber.com
®.

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Summit 89372

Tabla de contenido