Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
SNAP IGNITION OPERATION
Always open the lid before igniting the burners
Each control knob has its own igniter electrode built in. To create a spark you must push the control knob in (A) and turn to "START/High"
(B).
This action will generate
gas flow and a spark to the burner lighting tube (C). You will hear a "snap" from the igniter. You will also see a 3" - 5" orange flame coming from the burner
lighting tube at the left side of the burner (D).
Continue
to hold the burner
control
knob in for two seconds after the "snap".
This will allow gas to flow completely
down the burner tube (E) and insure ignition.
Check that the burner is lit by looking through the cooking grates. You should see a flame. If burner does not light on first try, push control knob in and turn to OFF.Repeat
lighting
procedure a second time.
z_ WARNING:
if the burner still does not light, turn the burner control
knob to "OFF" and wait 5 minutes
to let the gas clear before
you try again or try to light with a match.
LIGHTING
Summary
lighting instructions are inside the left hand cabinet door.
burners,
or not waiting 5 minutes to allow the gas to clear if the
Note: Each control knob snap igniter creates a spark from the igniter electrode
to the
the energy for the spark by pushing
in the control
burner.
& WARNING: Check hose before each use of barbecue
for
nicks, cracking,
abrasions
or cuts. if the hose is found to
be damaged in any way, do not use the barbecue.
Replace
using only Weber _ authorized
the Customer
Service Representative
®.
MAIN BURNER LIGHTING
than the
Publicidad
Tabla de contenido
