Trouble Shooting - FujiFilm Zoom Date 90EZ Manual De Instrucciones

Tabla de contenido

Publicidad

TROUBLE SHOOTING

During operation
Problems
The shutter release won't
trip.
" " is blinking after loading
the film and closing the
camera back.
After loading the film and
closing the camera back,
the film is rewound and " "
is displayed.
The film rewound during
photographing.
The self-timer cannot be
set.
"
" is blinking and the shut-
ter can not be released.
42
Possible Causes
1 "
" symbol is blinking.
2 Power switch is not on.
3 Is "
" blinking on the LCD?
4 "
" is displayed on the picture coun-
ter.
Did you pull the end of the film out to
the FILM TIP mark when loading the
film?
Did you open the camera back so as
to remove the film without checking that
the motor has stopped and that "
displayed?
Did you press the
middle of the film?
Is the date correction mode on?
The camera is broken.
1 Replace the new batteries.
2 Press the POWER button.
3 The flash is charging. Wait until "
and is displayed. (The flash takes about 7 seconds
to charge.)
4 Remove the film, and load an unused roll.
Pull the end of the film out to the FILM TIP mark
and correctly load the film.
Check that the motor has stopped and that " " is
displayed. After that, open the camera back and
" is
remove the film.
button in the
Be sure not to move the
loaded in the camera.
Cancel the date correction mode.
Please contact a FUJIFILM authorized distributor.
Solutions
" stops blinking
button while film is
ENGLISH
Page
12
11
23
17
17
28,31
30
13

Publicidad

Tabla de contenido
loading

Tabla de contenido