OPERATION MANUAL AND INSTRUCTIONS
PARTS INCLUDED:
Instrument
2 off M10 x 100mm long screw (Fig. 1-a)
6 mm hex key
Operators Handbook
Calibration certificate (Fig. 1-b)
Power cable
Carry case
FEATURES AND FUNCTIONS
3 sizes available covering the calibration ranges of:
-
• 1,2 ÷ 60 Nm
• 8 ÷ 400 Nm
• 30 ÷ 1500 Nm.
5 digit resolution.
-
ISO 6789-1:2017 limit mode with single press selection for 20%, 60% & 100% target values.
-
NON ISO 6789-1:2017 limit mode with user defined tolerances.
-
The pictorial keys allow direct access to measurement modes..
-
Serial Port Connector for data output to computers and printers.
-
PRINT/NO PRINT (√ PRINT/X PRINT) feature for control of serial data output.
-
The last 5 readings taken are memorised on the display.
-
SET UP menu's for:
-
• Language of operation
• Limits mode required
• Units of measurement enabled/disabled
• Serial port communication parameters
• Thresholds for 'CLICK & CAM' mode
• Modes of measurement enabled/disabled.
OPERATING INSTRUCTIONS
Mounting positions
Securely mount the Dynatester transducer in the plane of operation required with the 2 fixing bolts
supplied. This can be to a bench top or wall.
CLOCKWISE ONLY CALIBRATING / TESTING (Fig. 2-a)
Torque tighten to 20 Nm. (or hand tighten bolts with hex key provided)
18
682/60
682/400
006820006
006820040
682/1500
006820150