Beta 682/60 Manual De Uso E Instrucciones página 24

OPERATION MANUAL AND INSTRUCTIONS
SERIAL PORT
- INTRODUCTION
The serial port is configured as DTE (Data Terminal Equipment) and conforms to RS-232-C
specifications.
Measurement mode
Track
Dial & Electronic
Click & Cam
- PARAMETERS
Parameter
Parity
Data-Stop bits
Baud rate
Output Limits
Output line feed
First character
Output units
Maximum number of characters per line = 24.
Transmitted data voltage levels are between +5 to +9 volts and –5 to -9 volts.
TIP. If the serial port is not communicating with other equipment try:
a) Check that control word on the Dynatester and the equipment receiving data match.
b) Check that the baud rate is set to the same as the equipment receiving data.
c) Check that the connecting lead is wired correctly at both ends if not using the lead
supplied.
d) Check if the equipment receiving data requires the units of measurement inhibited or
a leading character. This can be applicable when interfacing to Mitutoyo® equipment.
If the serial output is being overwritten set 'OUTPUT LINE FEED' to YES.
24
When 'PRINT' is pressed.
When 'ZERO' is pressed after a peak has been captured.
After a 1st peak has been captured.
Options
ODD, EVEN or OFF.
8-2, 8-1, 7-2, 7-1
1200, 2400, 4800, 9600 o 19200
YES or NO
YES or NO
- /+ & - /NONE
YES or NO
SET TO FACTORY DEFAULTS
Data output operation
Factory Defaults
'OFF'' The Parity Bit used for Parity Error
'8-2' The format per character
'9600' The speed of data output.
'YES' Limit status sent before data.
'NO' Line feed sent after data.
'-' Character sent before the data
'YES' Torque units sent after data.
Comments
Reset all settings.