Eco Mode; Reset Water Filter Counter; Self-Test; Setting The Brightness Of The Control Panel - Gaggenau RF411704 Instrucciones De Uso

en-us
Operating the appliance

Eco mode

Eco mode switches the appliance to energy-saving
operation.
The appliance automatically sets the following
temperatures:
Freezer compartment: +3 °F (-16 °C)
▯
Switching Eco mode on or off
Press à button to open the main menu.
1.
2. Press C button to move to the menu item Eco mode.
Press I/& button.
3.
The temperature is changed, and the display shows the
new temperature. When Eco mode is switched off, the
recommended temperature is set.
Note: You can also switch Eco mode on or off by
adjusting the temperature with A/@ buttons.

Reset water filter counter

After replacing the water filter, you have to reset the
water filter counter.
1. Press à button to open the main menu.
Use C button to move to the menu item Reset water
2.
filter counter.
3. Use ™ button to confirm and confirm the query again
with ™ button.
Note: The water filter counter will not be reset if you
abort the query or take longer than 10 seconds to make
an input.

Self-test

This function can be used to start fault analysis on your
appliance.
~ "Appliance self-test" on page 30
Setting the brightness of the control
panel
1. Press à button to open the main menu.
Press B button to move to the menu item Basic
2.
settings.
Press ™ button.
3.
16
4. Press % button to open the menu item Brightness.
Press B C buttons to set the required brightness.
5.
6. Press ™ button.
The setting is saved.
Press ' button to exit the menu.
7.

Setting the display screen

You can choose between the settings Reduced and
Standard. With the setting Reduced only the temperature
and active special functions are displayed on the control
panel after a short period without operation. If the touch
fields are touched, all keys will be visible again.
With the setting Standard all keys always remain visible.
1. Press à button to open the main menu.
2. Press B button to move to the menu item Basic
settings.
Press ™ button.
3.
4. Press C button to move to the menu item Display
screen.
5. Press % button.
Press B C buttons to move to the required setting.
6.
7. Press ™ button.
The setting is saved.
8. Press ' button to exit the menu.

Setting the touch field color

1. Press à button to open the main menu.
Press B button to move to the menu item Basic
2.
settings.
Press ™ button.
3.
4. Press C button to move to the menu item Touch field
color.
5. Press % button.
6. Press B C buttons to move to the required setting.
7. Press ™ button.
The setting is saved.
8. Press ' button to exit the menu.