Cleaning And Maintenance - cecotec CONGA 5090 Manual De Instrucciones

to clean a specific area in zigzag motion. The robot will clean the selected area and then will
return directly to the charging base. You can set more than 1 area at the same time. The robot
will only clean the area selected in the map, therefore it will go to the point and return to the
base without vacuuming.
It can only be activated from the App.
8. Spot mode: Select this mode if you want to clean thoroughly a specific point in the map,
making the most of the robot's maximum power. The robot will clean a 2x2 m zone in zigzag
motion and then will return directly to the charging base when cleaning is completed. The
robot will only clean the area selected on the map, therefore it will go to the point and return
to the base without vacuuming.
It can only be activated from the App.
9. Restricted Area mode: Select this mode and delimit in the map specific areas where you
do not want the robot to clean. You can set more than 1 restricted area at the same time on the
map.
It can only be activated from the App.
10. Twice mode: Use this mode to carry out a deep, thorough cleaning of your home. It can be
combined with Edge, Spiral, Spot or Smart Area modes. The robot will carry out 2 full cleaning
cycles and then will return directly to the charging base.

7. CLEANING AND MAINTENANCE

Main brush
1. Turn the robot around and press the main brush's release button to take the cover
out.
2. Take the main brush out and clean the compartment.
3. Clean the main brush with the provided tools and use water and soap if necessary.
4. Place the main brush in its position and fasten the cover's clip.
Note: Replace the main brush every 6-12 months to ensure efficient operating (depending on
the frequency and type of use).
1. Main brush cover
1
2. Tab
2
3. Main brush
3
4. Compartment
4
ENGLISH
41