Filling The Front Brake Reservoir With Brake Fluid; Adjusting The Position Of The Rear Brake Pedal; Checking The Travel Of The Rear Brake Pedal - SHERCO 450 SEF/R Manual De Propietario

450 SEF/R
Brakes (continued)

FILLING THE FRONT BRAKE RESERVOIR WITH BRAKE FLUID

2
3

ADJUSTING THE POSITION OF THE REAR BRAKE PEDAL

2

CHECKING THE TRAVEL OF THE REAR BRAKE PEDAL

114
1
A
1
1
A

WARNING
- The hydraulic fluid is highly corrosive.
- It can be dangerous to the skin.
- Read the recommendations on the container.
- Remove the two screws
Remove the cover
2
Fill the reservoir with brake fluid to the correct
level .
A
Level of brake fluid below
the top of the reservoir.
Minerva brake fluid
- Reinstall the membrane, the cover and the
screws.
The position of the brake pedal can be adjusted as
follows: loosen the lock nut
the screw to obtain the desired position.
2
Tighten the lock nut when the pedal is properly
located.
Brake pedal lock nut
Check the pedal travel (
- Remove the spring
- Operate the pedal several times
Rear brake pedal travel
- Replace the spring
If the travel does not meet the specification, refer
to the rear brake travel adjustment. (
.
1
and the membrane
3
5mm
loosen or tighten
1
M6 10Nm
p.114)
☛
1
3mm ≥
A
1
p.115)
☛
.
≥5mm