Reinstalling The Battery; Charging The Battery - SHERCO 450 SEF/R Manual De Propietario

450 SEF/R
Electrical system maintenance (continued)

REINSTALLING THE BATTERY

CHARGING THE BATTERY

118
- Insert the battery into place.
- Connect the positive cable to the battery.
- Connect the negative cable to the battery.
- Install the battery retaining bracket and tighten
1
Chassis screws
- Check the positioning of the battery cables to
- Replace the air filter (
- Replace the saddle (
The battery is a maintenance-free type. If the
vehicle is not used for an extended period, it is
recommended that the battery be disconnected
and stored in a dry place. See removing the
battery (
Check the voltage of the battery with a voltmeter :
Battery voltage
If the voltage is below the specification, remove
the battery and recharge it using a battery charger.
Battery charging
(12V)
Disconnect the charger after charging.
Install the battery (
the two screws .
1
make sure that they do not interfere with the
installation of the air filter.
p.117)
☛
p.118).
☛
M6 10Nm
p.100).
☛
p.99).
☛
>12.5V
0.5 A for 10 hours
or 5A for 30 minutes