Filling The Front Brake Reservoir With Brake Fluid; Adjusting The Position Of The Rear Brake Pedal; Checking The Travel Of The Rear Brake Pedal - SHERCO 250-300 SE/R 2013 Manual Del Propietário

Filling THe FrOnT BraKe reservOir WiTH BraKe FlUid

2
3

adjUsTing THe POsiTiOn OF THe rear BraKe Pedal

2

CHeCKing THe Travel OF THe rear BraKe Pedal

1
All manuals and user guides at all-guides.com
1
- The hydraulic fluid is highly corrosive.
- It can be dangerous to the skin.
- Read the recommendations on the container.
a
- Remove the two screws
Remove the cover
Fill the reservoir with brake fluid to the correct
level
Level of brake fluid below
the top of the reservoir.
Minerva brake fluid
- Reinstall the membrane, the cover and the
The position of the brake pedal can be adjusted as
follows: loosen the lock nut
the screw
Tighten the lock nut when the pedal is properly
located.
1
Brake pedal lock nut
Check the pedal travel (
- Remove the spring
- Operate the pedal several times
Rear brake pedal travel
- Replace the spring
a
If the travel does not meet the specification, refer
to the rear brake travel adjustment. (
h
aTTenTiOn
and the membrane
2
.
a
screws.
to obtain the desired position.
2
1
1
.
1
.
3
5mm
loosen or tighten
1
M6 10Nm
p.115)
☛
3mm ≥ ≥5mm
a
p.116)
☛
115