Reinstalling The Battery; Charging The Battery - SHERCO 125 SE RACING Manual Del Proprietário

ELECTRICAL SYSTEM MAINTENANCE

REINSTALLING THE BATTERY

1

CHARGING THE BATTERY

134
- Insert the battery into place.
- Connect the positive cable to the battery.
- Connect the negative cable to the battery.
- Install the battery retaining bracket and tighten the
two screws .
1
Chassis screws
- Check the positioning of the battery cables to make
sure that they do not interfere with the installation
of the air filter.
- Replace the air filter ( p.117).
- Replace the saddle ( p.116).
The battery is a maintenance-free type. If the vehicle
is not used for an extended period, it is recommended
that the battery be disconnected and stored in a dry
place. See removing the battery ( p.133).
Check the voltage of the battery with a voltmeter:
Battery voltage
If the voltage is below the specification, remove
the battery and recharge it using a battery charger.
Battery charging
(12V)
Disconnect the charger after charging.
Install the battery ( above).
M6 10Nm
>12.5V
0.5 A for 10 hours
or 5A for 30 minutes