To Change The Fm Reception Mode; Using The Cd Player; Normal Play - JVC RC-BZ6BU Manual De Instrucciones

Manual Presetting (Using the Re-
mote Control) ———————————
Number key(s) (hold for 2 seconds)
1. Select a band by pressing the TUNER
BAND button.
4 ¢
2. Press the or button to tune in a station.
3. Set the preset number by pressing and hold-
ing the number key on the Remote Control.
• To preset numbers 1 to 10: Press the number key and hold
down for 2 seconds.
• To preset numbers 11 to 15: Press and release the +10 but-
ton, then press the second number key (1 to 5) and hold
down for 2 seconds.
When the preset display blinks, the setting is stored and you can
release the number key. The display returns to the normal band
and frequency display.
Example: Preset number = 12

Using the CD Player

Number keys
REPEAT
8
/
¢
7
4
REMOTE CONTROL RM-SRCBZ6
You can use Normal or Repeat Play. Repeat Play can be set to repeat
all or just one of the tracks on the CD.
One Touch CD Player
(AC power only) ——————————
6
Just press the CD button.
• The power is automatically turned on. If a CD is already
inserted, "PLAY" is displayed and the CD will start play-
ing from the first track.
• If no CD is inserted, "NO DISC" is displayed on the dis-
play and the CD Player remains in Stop mode.

Normal Play

1. Press the CD OPEN button on the Unit.
The CD holder opens.
2. Place a CD, with its label side up.
3. Gently close the CD holder by hand.
4. Press the CD 6 button.
6
4. Repeat steps 1 - 3 for each station.
To change the preset stations, repeat the same steps as above.
To Change the FM
Reception Mode
The "STEREO" indicator lights up and you can hear stereo effects,
when a program is broadcast in stereo.
However if an FM stereo broadcast is hard to receive or noisy, you
can select Monaural mode. Reception improves, but you lose any
stereo effect.
Press the TUNER BAND button to select FM
MONO mode.
The "MONO" indicator lights up on the display.
To restore the stereo effect, press the TUNER BAND button
to select FM Auto mode. The "MONO" indicator goes out.
4
¢
CD holder
CD OPEN
Playing time, Preset number
Track number
Repeat indicator
(Display when using the CD Player)
The first track of the CD begins playing.
The CD Player automatically stops when the last track of the CD has
finished playing.
• During playback, the track number being played and the play-
back time elapsed are shown on the display.
To stop playing the CD, press the
The following information for the CD is displayed.
Total number of tracks
To pause, press the CD
To cancel pause, press the CD
the point where it was paused.
Notes:
• You can place an 8 cm (3'') CD without an adaptor.
• If the CD cannot be read correctly (because it is scratched, for
example), "000000" appears on the display.
• Even if other function is selected during playing the CD, the
last track is memorized.
JOG dial
6
7
CD indicator/
Analog clock
7
button.
Playback time elapsed
6
.
6
again. Play continues from