Specifications; Cutting Attachment - Stihl MS 880 Manual De Instrucciones

English / USA

Specifications

EPA:
The Emission Compliance Period
referred to on the Emissions
Compliance Label indicates the number
of operating hours for which the engine
has been shown to meet Federal
emission requirements.
Category
A = 300 hours
B = 125 hours
C = 50 hours
CARB:
The Emission Compliance Period used
on the CARB-Air Index Label indicates
the terms:
Extended = 300 hours,
Intermediate = 125 hours,
Moderate = 50 hours
Engine
STIHL single cylinder two-stroke engine
Displacement: 7.42 cu.in
(121.6 cm
Bore: 2.36 in (60 mm)
Stroke: 1.69 in (43 mm)
Idle speed: 2,700 rpm
58
Ignition System
Type: Electronic magneto ignition
Spark plug (suppressed):
Bosch WSR 6 F or NGK BPMR 7 A
Electrode gap
0.02 in (0,5 mm)
Carburetor
All position diaphragm carburetor with
integral fuel pump
Fuel tank capacity
2.75 US pt (1.3 l)
Chain lubrication
Fully automatic, speed-controlled
reciprocating oil pump. Additional
manual oil flow control
Oil tank capacity
1.5 US pt (0,7 l)
Weight (without bar and chain
21.8 lb (9,9 kg)
3
)

Cutting Attachment

Recommended cutting attachments
for compliance with § 5.11 of ANSI
Standard B 175.1-2000
(see page 14 of this Manual):
STIHL reduced kickback bar
(with green label) for 3/8" pitch:
Rollomatic "S" with sprocket nose
43 or 53 cm (17 or 21 in)
STIHL low kickback chain
(with green label) for 3/8" pitch:
9,32 mm (3/8") Rapid-Micro 2
(36 RM 2)
Chain sprocket:
8-tooth for 3/8" pitch spur sprocket
)
1)
See definition of "low kickback
chain" on page 17.
1)
MS 880