Replacing Starter Rope And Rewind Spring - Stihl MS 880 Manual De Instrucciones

English / USA
Replacing Starter Rope
and Rewind Spring
1
1
1
2
3
4
: Remove the screws (1).
:
Push the hand guard up.
:
Pull underside of fan housing away
from crankcase and remove it
downward.
:
Use screwdriver or suitable pliers to
carefully remove spring clip (2) from
the starter post.
: Carefully remove the rope rotor
with washer (3) and pawls (4). Take
care not to pull the rewind spring
(behind the rotor) out of the housing
during this process.
46
1
4
: Use a screwdriver to pry the rope
out of the starter grip.
: Remove remaining rope from the
rotor and grip.
Thread the new rope through the
top of the grip and the rope bush (5).
:
Thread the rope through the rotor
and secure it with a simple
overhand knot.
: Coat rope rotor bearing bore with
non-resinous oil –
Slip rotor over starter post – turn it
back and forth to engage anchor
loop of rewind spring.
5
2
3
4
: Refit the pawls (4) in the rotor.
: Fit the washer (3) on the starter
post.
:
Use screwdriver or suitable pliers to
install spring clip (2) on starter post
and engage it on the pawls – the
spring clip must point clockwise –
see illustration.
4
MS 880