Features; Product Specifications - Ryobi WS730 Manual Del Operador

If the saw is used with an extension cord, ensure the con-
nection of the tool's power cord and the extension cord are
not on the ground.
If a protected outlet is not available, do not use the saw
until an outlet can be changed or auxiliary protection can
be obtained. These auxiliary protection devices are available
at your local retailer.
POSITION OF THE TILE SAW
See Figure 2, page 17.
To avoid the possibility of the tool plug or outlet getting
wet, position tile saw to one side of a wall-mounted outlet
to prevent water from dripping onto the outlet or plug. The
operator should arrange a "drip loop" in the cord connecting
the saw to the outlet. The "drip loop" is that part of the cord

PRODUCT SPECIFICATIONS

Blade Diameter .............................................................7 in.
Blade Arbor .............................................................. 5/8 in.
Throat Capacity ..................................................... 9-1/2 in.
Rip Capacity (tile size) ................................................16 in.
KNOW yOUR TILE SAW
See Figure 3, page 18.
The safe use of this product requires an understanding of
the information on the tool and in this operator's manual as
well as a knowledge of the project you are attempting. Before
use of this product, familiarize yourself with all operating
features and safety rules.
7 in. TILE CUTTING WHEEL - A 7 in. tile cutting wheel is
included with your saw.
WARNING:
Do not use wheels rated less than the speed of this tool.
Failure to heed this warning could result in personal
injury.
BEVEL BLOCK - Bevel block supports tile for fast, clean,
and consistent 45º edges.
NOTE: Only use bevel block on the right-hand side of the
table.
ELECTRICAL
below the level of the outlet, or the connector if an extension
cord is used, to prevent water traveling along the cord and
coming in contact with the outlet.
If the plug or outlet does get wet, DO NOT unplug the cord.
Disconnect the fuse or circuit breaker that supplies power
to the tool then unplug and examine for the presence of
water in the outlet.
WARNING:
To reduce the risk of electrocution, keep all connections
dry and off the ground. Do not touch the plug with wet
hands.

FEATURES

Diagonal Capacity (tile size) .......................................12 in.
Maximum Depth of Cut ......................................... 2-1/4 in.
Rating .............................................120 V~, 60 Hz, 9 Amps
No Load Speed .....................................5,800 r/min. (RPM)
CLEAN WAVE WALL™ - If you purchased the optional pump,
the Clean Wave Wall™ system helps prevent sediment from
entering the pump to extend pump life.
NOTE: Optional pump sold separately.
EASy GLIDE TABLE™ - For precise and accurate cuts.
END-OF-CUT REMINDER - End cut reminder prevents
chips and broken tiles by slowing down the Easy Glide Table
at the end of a cut. Also acts as hose holder.
FLOW ADJUSTMENT VALVE - Turns water flow to the cut-
ting wheel either on or off. When used with the optional water
pump, this feature becomes a variable flow adjustment.
MOTOR - This machine has a strong motor with sufficient
power to handle tough cutting jobs. It also has externally
accessible brushes for ease of servicing.
ON/OFF SWITCH - This saw has an easy access power
switch located below the front rail. To lock the switch in the
OFF position, remove the switch key from the switch. Place
the key in a location that is inaccessible to children and oth-
ers not qualified to use the tool.
9 — English