Ryobi RY80935 Serie Manual Del Operador página 19

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

NOTICE:
The use of a pump protector is strongly recommended
after each use and before storing to prevent cold weather
and seal damage during storage.
 Drain the lubricant and replace with fresh, clean lubricant
as described in the engine manual.
 Disconnect spark plug wire and remove the spark plug.
Pour about a teaspoon of clean, air-cooled, four-cycle
oil through the spark plug hole into the combustion
chamber.
 Leaving the spark plug out, pull the starter cord two or
three times to coat the inside of the cylinder wall.
 Inspect the spark plug and clean or replace, as necessary.
 Reinstall the spark plug, but leave the spark plug wire
disconnected.
 Clean the air filter.
PERIODIC MAINTENANCE SCHEDULE TABLE
NOTE: If a separate engine manual is provided for this pressure washer, please follow the maintenance schedule provided
in the engine manual for all engine maintenance items instead of the maintenance information listed below.
Maintenance Items
Clean engine & check bolts & nuts
Check engine lubricant
Change engine lubricant
1
Check water inlet filter placement
Add fuel stabilizer
Add pump protector
Clean spark plug
Clean air cleaner
Replace air cleaner element
Clean & adjust spark plug & electrodes
Replace spark plug
Remove carbon from cylinder head
Check & adjust valve clearance
Initial lubricant change should be performed after the first 20 hours of operation. Do not pour old lubricant down sewage
1
drains, into garden soil, or into open streams. Your local zoning or environmental regulations will give you more detailed
instruction on proper disposal.
If water inlet filter is missing or damaged, it must be replaced. See Replacement Parts List for part number to order.
2
Have performed by your nearest service center
3
MAINTENANCE
Each
use
X
X
X
2
X
X
X
3
3
Page 15 — English
 Extend the starter grip and rope rope to check its condi-
tion. If the rope is frayed, have it replaced immediately
by an authorized service center.
 Remove all hoses. Coil the hoses and store as shown.
Do not allow the hose to become kinked.
 Store the unit and accessories in an area that does not
reach freezing temperatures. Do not store near furnace or
other sources of heat that could dry out the pump seals.
PREPARING FOR USE AFTER STORAGE
 Pull the starter grip and rope grip three or four times to
clean lubricant from the combustion chamber.
 Remove spark plug from the cylinder. Wipe oil from the
spark plug and return it to the cylinder.
 Reconnect the spark plug wire.
 Refuel the machine as described earlier in the operator's
manual.
Every
Every
8 hrs.
20 hrs.
50 hrs.
X
X
Every
Every
Every
100 hrs.
300 hrs.
X
X
X
X
X
X
X

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido