Metabo HPT C 3610DRA Manual De Instrucciones página 21

Indicator
(For bevel scale)
Fig. 20-b
Adjustment bolts
Fig. 20-c
9. 90° Indicator (For bevel scale) adjustment (Fig. 20-b)
(1) When the blade is exactly 90° (0°) to the table,
loosen the bevel pointer screw using a #2 Phillips
screwdriver.
(2) Adjust Indicator to the "0" mark on the bevel scale
and retighten the screw.
10. 45° Left bevel adjustment
(1) Fully extend the sub fence (B) completely to the left,
and then pull the set pin (A) towards the front of the
machine.
NOTE
When retracting the set pin (A), it may be necessary to
shift the miter saw upper arm assembly to the left/right
to release the holding pressure.
Bevel pointer
screw
Set pin (A)
Locknut
Bolt
Fig. 21
(2) Loosen the bevel lock handle and tilt the gear case
completely to the left.
(3) Using a combination square, check to see if the
blade is 45° to the table.
(4) To adjust, tilt the gear case to 0°, loosen the
locknut, and turn the bolt in or out to increase or
decrease the angle as shown in Fig. 21.
(5) Tilt the gear case back to the left, and recheck
alignment.
(6) Repeat steps until the blade is 45° to the table.
Once alignment is achieved, tighten locknut and
bevel lock handle when alignment is achieved.
11. 45° Right bevel adjustment
Locknut
Bolt
Hex screw
Fig. 22
(1) Set the miter angle to 0°. Fully extend the sub fence
(A) completely to the right, and then pull the set pin
(A) towards the front of the machine.
NOTE
When retracting the set pin (A), it may be necessary
to shift the mitre saw upper arm assembly to the
left/right to release the holding pressure.
(2) Loosen the bevel lock handle and tilt the gear case
completely to the right.
(3) Using a combination square, check to see if the
blade is 45° to the table.
(4) To adjust, tilt the gear case to 0°, loosen the
locknut, and turn the bolt in or out to increase or
decrease the angle as shown in Fig. 22.
(5) Tilt the cutting arm back to the right, and recheck
alignment.
(6) Repeat steps until the blade is 45° to the table.
Once alignment is achieved, tighten locknut and
bevel lock handle when alignment is achieved.
12. 33.9° Left and right bevel adjustment
(1) Set the mitre angle to 0°. Fully extend both sub
fences (A, B).
(2) Loosen the bevel lock handle, and tilt gear case to
the 33.9° right bevel positive stop by pushing on
the set pin (A) towards the rear of the machine.
English
21