Before Cutting - Metabo HPT C 3610DRA Manual De Instrucciones

English
6. Eye protection
Always wear eye protection with side shields that
meets the requirements of ANSI Standard Z87.1.
Ordinary eyeglasses do not provide adequate
protection because they do not contain impact
resistant safety glass.
WARNING
Operating the tool without wearing proper eye
protection may result in serious injury.
AFTER INSTALLING THE BATTERY TO THE TOOL,
CHECK THE OPERATION OF THE TOOL AS FOLLOWS:
7. Electric brake
This tool is equipped with an electric brake which will
typically stop the blade within 5 seconds after the
trigger switch is released.
Occasionally, there will be a delay in the brake
engaging which will result in a longer blade stopping
time. On rare occasions, the brake may not engage at
all and the saw blade will coast to a stop.
If the brake fails to engage frequently, depress and
release the trigger switch to turn the tool on and off
4 or 5 times. If the brake still does not engage, have
the tool serviced at a metabo HPT authorized service
center.
Always confi rm that the saw blade has completely
stopped before raising it from the workpiece.
The brake is not a substitute for a properly functioning
lower guard. Check the function of the lower guard
before each use. Serious personal injury may occur
if the lower guard does not move smoothly and cover
the blade properly.
WARNING
Please be aware of the reaction of the Motor
Head (Fig.1) when the brake is activated. Braking
causes the Motor Head to jerk downward and
the user should be prepared for this reaction,
especially when the trigger switch is released
before the blade is completely down. Failure to
be familiar with, and prepared for, the operational
characteristics of the tool may cause serious
injury.
8. Trial Run
After confi rming that no one is standing behind,
the power tool start and confi rm that no operating
abnormalities exist before attempting a cutting
operation.
18
9. Inspect the rotating stability of the saw blade.
For precise cutting, rotate the saw blade and check for
defl ection to confi rm that the blade is not noticeably
unstable; otherwise vibrations might occur and cause
an accident.

BEFORE CUTTING

1. Positioning the table insert
4 mm
machine
screw
[Right angle cutting]
Fig. 15-a
4 mm
Saw blade
machine
screw
[Left bevel angle cutting]
Fig. 15-b
Saw blade
Table insert
[Right bevel angle cutting]
Fig. 15-c
Table inserts are installed on the turntable. When
shipping the tool from the factory, the table inserts
are so fi xed that the saw blade does not contact them.
The burr of the bottom surface of the workpiece is
remarkably reduced, if the table insert is fi xed so that
the gap between the side surface of the table insert
and the saw blade will be minimum. Before using
the tool, eliminate this gap in accordance with the
following procedure.
Saw blade
Table insert
Table insert
4 mm
machine
screw