Metabo HPT C 3610DRA Manual De Instrucciones página 23

15. Setting the cutting depth (Fig. 24-b)
The depth of cut can be preset for even and repetitive
shallow cuts.
(1) Adjust the cutting head down until the teeth of the
blade are at the desired depth.
(2) While holding the upper arm in that position, turn the
stop knob until it touches the anchor plate.
(3) Recheck the blade depth by moving the cutting head
front to back through the full motion of a typical cut
along the control arm.
NOTE
If the anchor plate becomes loose, it can interfere with
raising and lowering the cutting head. The anchor
plate must be tightened in horizontal position as
shown in Fig. 24-b.
16. The laser guide
WARNING
● For your own safety, never insert the battery or
AC/DC adaptor to tool until all the adjustment
steps are complete and you have read and
understood the
instructions.
● Your tool is equipped with a laser guide using a
Class llla laser guide. The laser guide allows you
to preview the saw blade path on the workpiece
to be cut before starting the miter saw. This laser
guide is powered by the transformed alternating
current supply directly through the power lead.
The saw must be connected to the power source
and the laser on/off switch must be turned on for
the laser line to show.
safety and operational
(1) Avoid direct eye contact
WARNING
* Laser radiated when laser guide is turned on.
Avoid direct eye contact.
*
CAUTION
● Use of controls or adjustments or performance
of procedures may result in hazardous radiation
exposure.
● The use of optical instruments with this product
will increase eye hazard.
WARNING
Do not attempt to repair or disassemble the
laser. If unqualifi ed persons attempt to repair
this laser product, serious injury may result. Any
repair required on this laser product should be
performed by a qualifi ed service dealer.
English
Fig. 25
23