Preparation Before Operation - Metabo HPT C 3610DRA Manual De Instrucciones

APPLICATIONS
Wood and aluminum sash.

PREPARATION BEFORE OPERATION

Make the following preparations before operating the
power tool:
1. Remove all packing materials attached or connected
to the tool before attempting to operate it.
2. Installation
11/32" (9 mm)
4 holes
10-23/64"
(263 mm)
Base 5/16" (8mm) bolt
Work bench 5/16" (8 mm) nut
Attach the power tool to a level, horizontal work bench
in accordance with Fig. 6.
Select 5/16" (8 mm) diameter bolts suitable in length
for the thickness of the work bench.
Bolt length should be at least 1-9/16" (40 mm) plus the
thickness of the work bench.
For example, use 2-9/16" (65 mm) or larger bolts for a
1" (25 mm) thick work bench.
The support rod ass'y attached to the rear of the base
helps stabilize the power tool.
11-39/64"
(295 mm)
Fig. 6
Installing the support rod ass'y
Insert one support rod ass'y into the hole located at
the rear of the base and push it in as far as it will go.
Thread the 5 mm screw into the hole next to the
mounting hold.
Firmly tighten the 5 mm screw with a screwdriver.
Repeat the above steps for installing the other support
rod ass'y.
5 mm screw
Support rod ass'y
3. Releasing the locking pin
When the power tool is prepared for shipping, its main
parts are secured by a locking pin.
Press the handle slightly down and pull out the locking
pin to disengag the cutting head.
NOTE
Lowering the handle slightly will enable you to
disengage the locking pin more easily and safely.
The lock position of the locking pin is for carrying and
storage only.
English
Hole
Fig. 7
Switch Handle
Locking pin
Pull
Fig. 8
13