About Remaining Battery Indicator; Maintenance And Inspection - Metabo HPT C 3610DRA Manual De Instrucciones

English
(7) Verify the operation of the lower guard does not bind
or stick.
(8) Be sure the spindle lock is released so the blade turns
freely.
CAUTION
Never attempt to install saw blades larger than
10" (255 mm) in diameter.
Always install saw blades that are 10" (255 mm)
in diameter or less.

ABOUT REMAINING BATTERY INDICATOR

You can check the battery's remaining capacity by
pressing the remaining battery indicator switch to light the
indicator lamp. (Fig. 50, Table 5)
The indicator will shut off approximately 3 seconds after
the remaining battery indicator switch is pressed.
It is best to use the remaining battery indicator as a
guide since there are slight diff erences such as ambient
temperature and the condition of the battery.
Also, the remaining battery indicator may vary from those
equipped to a tool or charger.
Remaining battery
indicator lamp
Display panel
State of lamp
Lights ;
The battery remaining power is
over 75%.
Lights ;
The battery remaining power is
50% – 75%.
Lights ;
The battery remaining power is
25% – 50%.
Lights ;
The battery remaining power is
less than 25%.
34
Remaining battery
indicator switch
Fig. 50
Table 5
Battery Remaining Power
Blinks ;
The battery remaining power is nearly
empty. Recharge the battery soonest
possible
Blinks ;
Output suspended due to high
temperature. Remove the battery
from the tool and allow it to fully cool
down.
Blinks ;
Output suspended due to failure or
malfunction. The problem may be the
battery so please contact your dealer.
The Table 5 shows the state of remaining battery indicator
lamp and the battery remaining power.
NOTE
Do not give a strong shock to the display panel or
break it. It may lead to a trouble.

MAINTENANCE AND INSPECTION

WARNING
To avoid an accident or personal injury, always
confi rm that the trigger switch is turned OFF
and pull out the battery before performing any
maintenance or inspection of this tool.
1. Inspecting the saw blade
Always replace the saw blade immediately upon the
fi rst sign of deterioration or damage.
A damaged saw blade can cause personal injury and
a worn saw blade can cause ineff ective operation and
possible overload to the motor.
CAUTION
Never use a dull saw blade. When a saw blade is
dull, its resistance to the hand pressure applied
by the tool handle tends to increase, making it
unsafe to operate the power tool.
2. About Handling the Motor (see Fig. 1)
Winding of the motor is said to be the heart of this tool.
Exercise utmost caution not to damage the winding by
exposing it to wash oil or water.
NOTE
Accumulation of dust and the like inside the motor can
result in a malfunction.
After using the motor for 50 hours or so, carry out
no-load running, and blow in the dry air from a wind
hole at the motor's rear. Such action is eff ective to
discharge dust and the like.