Foppapedretti SuperTres Manual De Instrucciones página 84

GB
TO USE
belt and no air bag.
THE TYPE OF APPROVED SEAT BELT YOU MUST HAVE Fig. 15.
Your child seat can only be installed rearward facing using a lap and diagonal seat belt in the
front or rear passenger seat of the car Fig.16.
INSTALLATION
- Push the child seat facing rearward firmly against the backrest of the car's seat Fig.16.
- Route the lap section of the adult safety belt through the lap belt guides and fasten the car
seat belt Fig.17, Fig.18.
- Place the diagonal belt in the diagonal seat belt guide at the back of the seat Fig.18.
- Take out all the slack in the seat belt, ensuring that there are no twists or kinks in the seat
belt Fig.19.
THE HANDLE POSITIONS
To adjust the handle from one position to another, pull out both sides of the handle on the
swivel point; rotate the handle forwards or backwards into the desired position:
The carry handle has four positions:
- Forward in the car Fig.20.
- Straight up for carrying Fig.21.
- Against the car seat for rocking Fig.22.
- Stop rocking Fig 23.
Always ensure that the handle is locked in position and that the harness is correctly fitted and
the buckle fastened before lifting your car seat.
CANOPY ASSEMBLY
Insert frame through sleeve of canopy Fig.24.
NOTE: Curved side of canopy frame must Point towards canopy material.
Insert keys on both ends of canopy frame into keyholes on car seat casting located above
handle hubs Fig.25.
Rotate canopy frame back.
HINT:It may be helpful to detach side of seat pad to see keyholes.
This child seat can be installed into the appointed stroller as the travel system
"SUPERTRES".
16
SuperTres