Tension Diamond Abrasive Chain; Check Tension Of Diamond Abrasive Chain - Stihl GS 461 Manual De Instrucciones

Tension diamond abrasive
chain
1
For retensioning during operation:
Switch off the engine
N
Put on protective gloves
N
Loosen nuts
N
Raise the guide bar at the nose
N
Use the screwdriver to turn the
N
screw (1) to the right until the
distance (a) = approx. 0.2 in
(5 mm)
If the distance (a) = approx. 0.2 in
(5 mm) cannot be set due to an
elongated diamond abrasive chain,
move guide bar – see installing "guide
bar and diamond abrasive chain".
Raise the guide bar further and
N
tighten the nuts securely
GS 461
Check tension of diamond abrasive
N
chain – diamond abrasive chain can
be pulled across the guide bar by
hand
A new diamond abrasive chain must be
retensioned more frequently than one
that has been in use already for an
extended period.
Check chain tension frequently –
N
see "Operating Instructions"
Check tension of diamond
abrasive chain
a
Switch off the engine
N
Diamond abrasive chain can sag a
N
maximum of a = 0.6 in (15 mm)
Retension diamond abrasive chain
N
if necessary – see "Tensioning the
diamond abrasive chain".
If the diamond abrasive chain sags too
much, this leads to significantly
increased wear of the cutting
attachment.
A new diamond abrasive chain must be
retensioned more frequently than one
that has been in use already for an
extended period.
Check chain tension frequently –
N
see "Operating Instructions"
English
19