Stihl GS 461 Manual De Instrucciones página 18

English
Cutting round and hollow bodies
Secure pipes, round bodies, etc.
N
against rolling away.
Mark a cutting line - when
N
determining the cutting line, avoid
reinforcement, especially in the
direction of the severing cut.
Make the plunge cut very carefully.
N
Feed with bar completely through
N
the wall of the workpiece along the
cutting line – for small corrections of
direction, do not tilt the diamond
abrasive chain, but always position
it anew instead – if necessary, use
wedges and if necessary, leave
small ridges that hold the part that is
to be separated in position. Break
these ridges later.
16
Shaping pipe
Secure pipes, round bodies, etc.
N
against rolling away.
Mark a cutting line - when
N
determining the cutting line, avoid
reinforcement, especially in the
direction of the severing cut.
WARNING
Manual cutting along this line requires
particular caution and precision.
Cut into pipes, round bodies, etc. in
N
the area at the ends of the cutting
line a short distance, so that the
material does not break away.
Make the plunge cut very carefully
N
at the apex and cut outward on both
sides - feed with full cutting depth
along the cutting line – for small
corrections of direction, do not tilt
the diamond abrasive chain, but
always position it anew instead – if
necessary, use wedges and if
necessary, leave small ridges that
hold the part that is to be separated
in position. Break these ridges later.
GS 461