Switch Trigger - Ryobi TS1345L Manual Del Operador

FEATURES
POSITIVE STOPS ON MITER TABLE
SWITCH
Positive stops have been provided at 0°, 15°, 22-1/2°, 31.6°,
TRIGGER
and 45° on both the left and right side of the miter table.
SPINDLE
SELF-RETRACTING LOWER BLADE GUARD
LOCK
BUTTON
The lower blade guard is made of shock-resistant, see-
through plastic that provides protection from each side of
the blade. It retracts over the upper blade guard as the saw
is lowered into the workpiece.
SPINDLE LOCK BUTTON
See Figure 4.
The spindle lock button locks the spindle stopping the
blade from rotating. Depress and hold the lock button while
installing, changing, or removing blade.

SWITCH TRIGGER

See Figure 4.
To prevent unauthorized use of the compound miter saw,
disconnect it from the power supply and lock the switch in
the OFF position. To lock the switch, install a padlock (not
included) through the hole in the switch trigger and make
certain the switch is inoperable. If the switch is still operable
with the padlock installed, a padlock with a larger shackle
diameter must be used. Store the padlock key in another
location.
SWITCH
TRIGGER
PADLOCK
Fig. 4
11 — English