Seat Height; Back Rest; Adjusting The Angle; Arm Rests - B+B Centuro S2 Manual De Instrucciones

Centuro S2
| Scooter
Moving the seat
• Pull the lever (on the right below the seat surface, Fig. 05) towards
you. The seat can now be moved forwards and backwards.
• You can now adjust the seat to the required position.
• Release the lever and ensure that the seat is locked in one of the
closest fixed positions.
05

Seat height

• You will firstly need to remove the seat.
• Fold the back rest onto the seat by holding the back rest with your
right hand and using your left hand to lift up the lever on the
left next to the seat surface (Fig. 08). The back rest will then fold
forwards automatically.
• Simply remove the seat by pulling it upwards (Fig. 06).
• Undo the screw connection (Fig. 07) and position the seatpost in
06
the required position inside the tube guide.
• Then securely tighten the screw connection again (Fig. 07) in the
next hole.
• Now place the seat back onto the mounting.
• Make sure that it is locked in position again.

3.5.3. Back rest

07
The angle of the back rest on your scooter can be adjusted forwards
and backwards.. You also have the possibilty to limit the adjustment
range backwards.

Adjusting the angle

• Pull the lever (on the left on the seat, Fig. 08) upwards. The back
now pushes forwards.
• Push the back rest into the required position.
08
• Release the lever and make sure that the back rest is locked in
position again.
50

3.5.4. Arm rests

The arm rests can be swivelled upwards in order to make it easier to
mount and dismount. In addition, the height, distance and angle of
support of the arm rests can be adjusted.
Height
• Undo the hand screw until you can pull it out, and hold the
screw in position. The armrest can now be adjusted upwards or
downwards (Fig. 09).
• Move the armrest to the required height and tighten the screw
again.
Side distnace
• Undo the hand screw (Fig. 10) on the back of the back rest frame
while holding onto the armrest.
• Adjust to the required distance and tighten the screw again.
• The armrests can also be removed (e.g. for replacement, storage or
transportation) after undoing the screw on the back of the frame
(Fig. 10).
Angle of support
• You can adjust the angle of support of the armrests by screwing
the knurled nut (Fig. 11) on the relevant armrest further in or by
unscrewing it.

3.5.5. Seat belt (optional)

The seat belt will be attached to the frame from the side.
• Adjust the belt length to meet your needs by positioning the clasp
accordingly.
• Fasten the belt with the belt buckle.
• Unfasten the belt by pressing the red button (Fig. 12) on the belt
buckle.
Bischoff & Bischoff GmbH |22.11.2019 - Revision: 1
Centuro S2
Scooter |
09
10
11
12
51