Taking Out Fuse Links; Checking The Condition Of Fuse Links; Sealing The Disconnector; Sealing By Sealing Wire - WEG FSW 400 Manual De Instrucciones

www.weg.net

4.2. TAKING OUT FUSE LINKS

Take off the cover (acc. to chapter 1.3);
g
Press the release button of locking for fuse links (Figure 23) and then pull out and take
g
out a fuse link from a fuse holder (Figure 24).

4.3. CHECKING THE CONDITION OF FUSE LINKS

Move a slide of the cover up in order to make clear the inspection holes (Figure 25);
g
Figure 25
Check the condition of fuse links e.g. by voltage tester (Figure 26);
g
Move down a slide of the cover until it gets measuring closed holes (Figure 27).
g

5. SEALING THE DISCONNECTOR

5.1. SEALING BY SEALING WIRE

Close the cover (acc. to chapter 1.2);
g
Place a seal by passing sealing wire through the eye 2 of sealing element and eye of a
g
handle 1 of the cover (Figure 28).
16 Instruction manual for mounting and service of fuse switch disconnectors
Figure 23
Figure 26
Figure 28
Figura 24
Figure 27
Figure 29