Mounting Of Conductors With Bare Terminal - S Type Bridge Clamp; Inserting, Taking Out And Checking The Conditions Of The Fuse Links; I Nserting Of The Fuse Links - WEG FSW 250 Manual De Instrucciones

3.2. MOUNTING OF CONDUCTORS WITH BARE TERMINAL - S TYPE
BRIDGE CLAMP
Take off the cover (acc. to chapter 1.3);
g
Take off the shields for terminals (acc. to chapter 1.5);
g
Fix the conductors with (M8 bolts, 10 Nm) (Figure 16);
g
Break down of appropriate elements of the shield for terminals (Figure 12, 13) and/or
g
(Figure 14, 15);
Mount the shields for terminals (acc. to chapter 1.6);
g
Mount the cover (acc. to chapter 1.4).
g
4. INSERTING, TAKING OUT AND CHECKING THE
CONDITIONS OF THE FUSE LINKS

4.1. I NSERTING OF THE FUSE LINKS

Take off the cover (acc. to chapter 1.3);
g
Place the fuse link in a fuse holder (Figure 17);
g
Move a fuse link along the cover until the locking for fuse links is fasten (Figure 18);
g
Mount the cover (acc. to chapter 1.4).
g
Instruction manual for mounting and service of fuse switch disconnectors
Figure 16
Figure 17 Figure 18
www.weg.net
15