Adjusting Bevel Scale Pointer - Bosch CM12SD Instrucciones De Funcionamiento

Tabla de contenido

Idiomas disponibles

BM 1609B04985 11-14_CM12SD 11/12/14 2:52 PM Page 18

WARNING

assembly, adjustment or repair to avoid possible

injury.

NOTE: Your miter saw was completely adjusted at the

factory.

However,

misalignment may have occurred. Check the

following settings and adjust if necessary prior to

using this miter saw.

Calibrating Blade at 0° Bevel

Note: Use a 10mm wrench for adjustment.

1. Lower head assembly and engage head assembly

lock pin.

2. Slide the head assembly completely to the back

and engage the slide rail lock knob by tightening

the knob to the right (clockwise).

3. Pull the bevel lock lever forward to unlock the head

assembly.

4. Make sure that the zero bevel detent is pushed

back in position.

5. Locate the bevel stop bolt below the bevel lock

handle on the right side of the bevel post. This bolt

features a lock nut (see figure 16).

6. Loosen the bevel stop bolt a quarter turn and then

loosen the lock nut. When this is complete you will

be able to adjust the bevel stop bolt by hand.

A. Rotate the bevel stop bolt clockwise to adjust the

head to the right.

B. Rotate the bevel stop bolt counter-clockwise to

adjust the head to the left.

7. Follow the procedure in "Checking 0° Bevel

Setting" to check your modifications. If further

adjustment is required, repeat the steps above.

8. Once satisfactory, lock the bevel lock at 0° to

prevent movement.

9. Finger tighten the lock nut in place. Once secured,

tighten the lock nut with wrench.