Attaching Loose Parts - Bosch CM12SD Instrucciones De Funcionamiento

BM 1609B04985 11-14_CM12SD 11/12/14 2:52 PM Page 11
1. Position square and
draw a light line
3/4" board with
straight top edge
WARNING
source before
adjustments or repairs.
Storing the 4/6mm Hex Key
There is a storage location on the saw to store the
4/6mm hex key.
Insert the long leg of the hex key through the slotted
hole on the base of the saw and short leg of the hex
key through the rubber grommet as shown in figure 1.
NOTE: The 4/6mm hex key is needed to change the
blade and to make tool adjustments.
Assembly
Combination Square Must Be True
Checking Combination Square
drawn line

Attaching loose parts

To avoid possible
disconnect plug from power
performing any assembly,
2. Flip square
3. Check edge of flipped
no gap or overlap
injury,
FIG. 1
4/6mm
Hex Key
11.
(shown in dotted position)
square against the drawn line.
There should be no gap or
overlap at the bottom end.
Grommet