Sears Kenmore 385.17126 Manual De Instrucciones página 109

Tabla de contenido

Publicidad

Measuremenl
markings
Buttonhole
Making
(Continued)
4, a.
b.
C.
d.
e.
NOTE:
Mark your buttonhole position carefully on the garment.
Placing your garment behind the machine, insert it between the guide plate
and the buttonhole foot as shown.
Align marked buttonhole with center marking on buttonhole foot.
Line up your fabric edge with the measurement markings on the guide plate
lust in front of the buttonhole foot as shown.
Pierce the fabric with the needle at the beginning of the buttonhole.
If you want your buttonhole to be 1/2 inch from the garment edge, line up
the fabric with the 1/2 inch markings
each time you start to sew a
buttonhole.
We recommended
the use of interfacing when making buttonholes.
If the fabric does not feed smoothly from the start, increase the stitch
length
5. a. Lower the buttonhole foot.
b. Start sewing slowly.
c, Allow the machine to do the work by itself.
(Do not try to guide the fabric.)
d, Stop sewing when the needle returns to the position where it begins.
To release the buttonhole base plate, pull the lever toward you and lift the base
plate off the machine.
Adjusting the stitch density
You may alter the closeness ot the stitches by turning the stitch length control
between 3 and 4.
LENGTH
t
Fine stitches for lighl
(abncs
Coarse st(tches
for heavv fabncs
k_..
102

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Kenmore 385.17826

Tabla de contenido