Cleaning The Condenser - Polar Refrigeration DN492 Manual De Instrucciones

Telephone Helpline: 0845 146 2887 (United Kingdom)

Cleaning the condenser

Please ensure that the Blast Chiller is switched off and unplugged prior to cleaning
Clean the condenser periodically.
As the fins of the condenser are very sharp, always wear protective gloves for the next phases. Use
protective masks and glasses in the presence of dust.
Whenever the condenser has a deposit of dust in correspondence with the fins, this can be removed using a
suction device or with a brush applied, using a vertical movement along the direction of the fins.
No other instruments must be used, which may deform the fins and therefore the efficiency of the
appliance.
To clean, proceed as follows:
1. Open the door (A) of the appliances.
2. Remove the lower panel (B) from the technical compartment: to do this, remove the screw fasteners
(C).
3. It is now possible to clean the finned part of the condenser (D) using suitable tools and protection
devices.
4. After cleaning, close the control panel and fix it with the screws removed beforehand.
UK
9