Cleaning The Condenser; Troubleshooting - Polar Refrigeration CE210 Manual De Instrucciones

Telephone Helpline: 0845 146 2887 (United Kingdom)

Cleaning the Condenser

Periodically cleaning the condenser can extend the life of the appliance.

Troubleshooting

If your POLAR appliance develops a fault, please check the following table before making a call to the
Helpline or your POLAR retailer.
Fault
The appliance is not
working
The appliance turns on, but the
temperature is too high/low
The appliance is leaking
water
The appliance is
unusually loud
Probable Cause
The unit is not switched on
Plug and lead are damaged
Fuse in the plug has blown
Power supply
Internal wiring fault
Too much ice on the evaporator
Condenser blocked with dust
Doors are not shut properly
Appliance is located near a heat source
or air flow to the condenser is being
interrupted
Ambient temperature is too high
Unsuitable foodstuffs are being stored
in the
appliance
Appliance is overloaded
The appliance is not properly levelled
The discharge outlet is blocked
Movement of water to the drain is
obstructed
The water container is damaged
The drip tray is full
Loose nut/screw
The appliance has not been installed in
a level or stable position
Action
Check the unit is plugged in correctly
and switched on
Call POLAR agent or qualified
Technician
Replace the fuse
Check power supply
Call POLAR agent or qualified
Technician
Defrost the appliance
Call POLAR agent or qualified
Technician
Check doors are shut and seals are
not damaged
Move the refrigerator to a more
suitable location
Increase ventilation or move
appliance to a cooler position
Remove any excessive hot foodstuffs
or blockages to the fan
Reduce the amount of food stored in
the appliance
Adjust the screw feet to level the
appliance (if applicable)
Clear the discharge outlet
Clear the floor of the appliance (if
applicable)
Call POLAR agent or qualified
Technician
Empty the drip tray (if applicable)
Check and tighten all nuts and screws
Check installation position and
change if necessary