Cleaning The Condenser; Removing The Doors (Sliding Doors Only); Replacing The Bulb; Replacing The Lamp - Polar Refrigeration G834 Manual De Instrucciones

UK

Cleaning the Condenser

Periodically cleaning the condenser can extend the life of the appliance. The condenser is located at the
back of the appliance.
Note: Use a soft brush or vacuum cleaner to clean the fins of the condenser, taking care
not to damage the fins.

Removing the Doors (Sliding Doors only)

When cleaning the appliance or replacing the lamp it may be necessary to remove the doors to improve
access.
To remove the doors:
Holding the sides of the first door, lift the door into the upper runner.
1.
Pull the bottom of the door out and down simultaneously so the door clears the bottom runner.
2.
Note: The automatic door-closing system means that the doors are attached to the
appliance by a cord. Do not break or remove this cord.
Place the door to the side of the appliance.
3.
Repeat for the remaining doors.
4.
To replace the doors, slot them into the upper runner and then push the bottom of the door in and
5.
down to slot it in to the bottom runner.

Replacing the Lamp

Switch Off and disconnect the appliance from the power supply.
1.
Remove the doors (G837/G838 Only) to improve access to the lamp housing.
2.
Unscrew the screws securing the plastic cover and light switch.
3.
Gently pull down the lamp and end caps from the clips so they clear the recess.
4.
Gently pull the end caps from the lamp.
5.
Insert a new lamp into the end caps and slot back in to the recess.
6.
Replace the plastic cover and the screws.
7.
Replace the doors (G837/G838 Only).
8.
3