Using The Charging Station - Keba KeContact P20 Manual Del Usuario

2

Using the charging station

Note
Depending on the design of the charging station, the parking bay may deviate from the one shown.
Starting the charging proce-
dure
The charging cable is nei-
ther plugged into to the ve-
hicle nor the charging sta-
tion.
Device with standard
socket:
Plug the charging cable
into the charging station
first.
Now plug the charging ca-
ble into the vehicle.
Ending the charging procedure
The charging procedure is ended by unplugging the charging cable at the vehicle. For details, please refer
to the instructions of the vehicle manufacturer.
Disconnect the charging cable from the vehicle ("Wait for unplugging").
Unplug the charging cable at the charging station resp. stow the charging cable on the provided holder
on the device.
Using the charging station
Typical version with charging cable
[A]...Status LED
[B1]...Parking bay for charging connector
[B2]...Standard socket (variants possible)
[C]...Housing cover
[D]...Hanger for charging cable
Storing the charging connector/charging cable
If no charging procedure is being performed, the charg-
ing connector can be plugged into the parking bay [B1]
for safe storage.
The charging cable can be coiled up and placed on the
hanger [D].
Status LED
The charging station must be ready for operation, the status LED flashes
green slowly every 3 seconds ("Ready for operation").
The status LED lights up orange ("Wait for locking") while the system at-
tempts to mechanically lock the plug. After successful locking, the status
LED flashes green again slowly every 3 seconds.
After the self-test (orange), the status LED lights up green continuously
("Ready for charging").
The charging procedure can be started from the vehicle from this point in
time; the status LED then flashes green ("Charging procedure").
en
23/200