Display Settings - JVC KD-T409 Manual De Instrucciones

AUDIO SETTINGS
Speaker output settings
[SPK/PRE OUT]
Select the output setting for the speakers [SPK/PRE OUT], based on the speaker
connection method.
Connection via lineout terminals
For connections through an external amplifier. (Page 19)
Setting on
[SPK/PRE OUT]
[REAR/REAR] Rear speakers output
[REAR/SUB.W] (default) Subwoofer output
[SUB.W/SUB.W] Subwoofer output
Connection via speaker leads
You can also connect the speakers without using an external amplifier
but still being able to enjoy the subwoofer output with these settings.
(Page 19)
Setting on
[SPK/PRE OUT]
[REAR/REAR] Rear speakers output
[REAR/SUB.W] Rear speakers output
[SUB.W/SUB.W] Subwoofer output
If [SUB.W/SUB.W] is selected:
– [FRQ 120HZ] is selected in [SUBWOOFER LPF] and [FRQ THROUGH] is not available.
(Page 11)
– [POSITION R01] is selected in [FADER] and selectable range is [POSITION R06] to
[POSITION 00]. (Page 11)
12
ENGLISH
Audio signal through lineout terminal
REAR/SW
Audio signal through rear speaker lead
L (left) R (right)
Rear speakers output
Rear speakers output
(Mute)

DISPLAY SETTINGS

Zone identification for brightness settings
KD-T409/
KD-T402:
KD-T401:
Zone identification for color settings
Symbolic button
KD-T401:
1 Press and hold .
2 Perform 'Select an item (page 3 or 4)' operation to select an
item (see page 13).
3 Repeat step 2 until the desired item is selected/activated or follow the
instructions stated on the selected item.
4
Press to exit.
To return to the previous setting item, press
(Symbolic button)
.