Starting / Stopping The Engine - Stihl MS 362 C-Q Manual De Instrucciones

English
Fitting the cover plate
2
2
1
N Place the cover plate (1) in position,
engage the two tabs (arrows), and
secure it with the screws (2).
32
Starting / Stopping the
Engine
Positions of Master Control lever
STOP
0
Stop 0 – engine off – the ignition is
switched off.
Normal run position F – engine runs or
can fire.
Starting throttle n – this position is
used to start a warm engine. The Master
Control lever moves to the normal run
position as soon as the throttle trigger is
squeezed.
Choke shutter closed l – this
position is used to start a cold engine.
Setting the Master Control lever
To move the Master Control lever from
the normal run position (F) to the starting
throttle position (n) or choke closed
position (l), press down the throttle
trigger interlock and squeeze the throttle
trigger at the same time.
Select choke shutter closed (l)
– If the engine is cold
– If the engine stalls when you open
the throttle after starting
– If the fuel was run until empty
(engine stopped)
Select starting throttle (n)
– If the engine is warm, i.e. if it has
been running for about one minute.
– When the engine begins to fire
– After clearing the flooded
combustion chamber
Holding the saw
There are two methods of starting the
saw.
MS 362 C