Starting / Stopping The Engine - Stihl MS 880 Manual De Instrucciones

1
if engine trouble occurs, first check
N
whether use of intake air pre-
heating is necessary
at higher temperatures, close the
N
opening with stoppers (1) (special
accessory)
MS 880
Starting / Stopping the
Engine
Positions of Master Control Lever
STOP
0
Stop 0 – engine off – the ignition is
switched off
Normal run position (F) – engine runs or
can fire.
Starting throttle (n) – this position is
used to start a warm engine. The Master
Control lever moves to the normal run
position as soon as the throttle trigger is
squeezed.
Choke shutter closed (l) – this position
is used to start a cold engine.
Setting the Master Control Lever
To move the Master Control lever from
the normal run position (F) to the starting
throttle position (n) or choke closed
position (l), press down the trigger
lockout and squeeze the throttle trigger
at the same time.
Choke shutter closed (l)
if the engine is cold
–
if the engine stalls when you open
–
the throttle after starting.
if the fuel tank was run until empty
–
(engine stopped).
Starting throttle position (n)
if the engine is warm, i.e. if it has
–
been running for about one minute.
When the engine begins to fire
–
after clearing a flooded combustion
–
chamber.
Holding the Saw
There are two ways of holding the saw
when starting.
English
37