Starting / Stopping The Engine - Stihl MS 200 T Manual De Instrucciones

English
Starting / Stopping the
Engine
The four positions of the Master
Control lever:
Stop 0 – engine off – the ignition is
switched off.
Normal run position F – engine runs or
can fire.
Warm start n – this position is used to
start a warm engine.
Cold start l – this position is used to
start a cold engine.
26
Setting the Master Control lever
To move the Master Control lever from
the normal run position (F) to cold start
(n), press down the throttle trigger
lockout and squeeze the throttle trigger
at the same time.
To select warm start (n), move the
Master Control lever to cold start (l)
first, then push it into the warm start
position (n).
The change to warm start (n) is
possible only from the cold start
position (l).
The Master Control lever moves from
warm start (n) to the normal run
position (F) as soon as the throttle trigger
is squeezed.
To switch off the engine, move the
Master Control lever to Stop 0.
Holding the saw
N Place your saw on the ground.
Make sure you have a firm footing –
check that the chain is not touching
any object or the ground.
N Hold the saw firmly with your right
hand on the top handle.
N Rest your right knee on the
carburetor box cover.
Start the engine.
Bystanders must be well clear of
the general work area of the saw.
Observe safety precautions.
MS 200 T