Starting / Stopping The Engine - Stihl MS 362 C-MQ Manual De Instrucciones

At temperatures above +70°F (+20°C)
Always return the shutter to the
N
summer position (s ) to avoid
engine running problems and
overheating.
At temperatures below +14°F (-10°C)
It is advisable to fit the cover plate kit
(special accessory) if you use your saw
in extremely cold conditions
(temperatures below +14 °F (-10°C), in
powder or drifting snow).
Cover plate
The cover plate (special accessory)
helps prevent snow being sucked into
the machine.
When the cover plate is fitted, the
shutter must be in the winter position.
In the event of engine running problems,
first check that conditions for use of the
cover plate still apply.
Fitting the cover plate
2
2
1
Place the cover plate (1) in position,
N
engage the two tabs (arrows), and
secure it with the screws (2).
MS 362 C-MQ
Starting / Stopping the
Engine
Positions of Master Control Lever
STOP or † – Master Control lever must
be pushed in direction of STOP or † to
switch off ignition. The Master Control
lever springs back to the run position F
when it is released.
WARNING
The ignition is switched on again
automatically after the engine stops.
Engine can be started by operating the
rewind starter.
Normal run position (F) – engine runs or
can fire.
Start } – the engine is started in this
position.
Setting the Master Control Lever
To move the Master Control lever from
the run position F to start }, depress
the trigger lockout and the throttle trigger
and hold them in that position – set the
Master Control lever to start } and let
go of the throttle trigger and trigger
lockout.
The Master Control lever moves from
the start position (}) to the run
position (F) when you press down the
throttle trigger lockout and squeeze the
throttle trigger at the same time.
To switch off the engine, move the
Master Control lever in the direction of
STOP or † – when released, the Master
Control lever springs back to the run
position F.
Holding the Saw
There are two ways of holding the saw
when starting.
English
35