Mi-T-M Corporation cm series Manual De Operation página 19

T e S T I N g g R O u N d fA u lT C I R C u I T
INTeRRuPTeR (gfCI)
CAuTION: ground fault Circuit Interrupter (gfCI)
muST be tested before each use of the washer.
If the results in each one of the following steps are
not as described, shut washer off immediately. dO
NOT operate until the washer has been inspected
by a qualified electrician or your dealer.
1. Plug GFCI into grounded receptacle. Connect high
pressure outlet hose and turn on water supply.
2. Press and release "RESET" button (A) to verify power
to the washer.
3. Press "TEST" button (B). Red indicator bar (C) on reset
button should appear. (Power to the washer should be
interrupted).
4. Press and release the "RESET" button. Power should
be restored to the washer.
NOTE: GFCI test instruction are also found on the front of
the GFCI.
Operator's Manual
Preparing the Washer
A
C
B
C
A
B
19