Singer CE-250 Manual De Instrucciones página 20

SETTING THE TOP THREAD
A. Raise the presser foot lifter. Always be sure to raise the
presser foot lifter before threading the top thread. (If the
presser foot lifter is not raised, correct thread tension
cannot be obtained.)
B. Turn the hand wheel toward you until the needle is in its
highest position and the thread take-up is visible.
C. Thread the machine in the following order as illustrated.
* Guide the thread through thread guide (1), and then pull
it down along the groove.
* Do a U-turn around the inside of the tab (2).
* Pass the thread through the thread take-up (3) from right
to left.
* Insert the thread into the inside of the groove (4).
* Guide the thread into the thread guide (5).
* Pass the thread through the eye of the needle (6) from
front to back.
1
Thread take-up
Releveur de fil
Tria- hilos
18
3
Tab
4
Languette
Lengüeta
2
5
6