Safety Notes - Chauvet Professional VIP 5162 Signal Processor Manual Del Usuario

Safety Notes

VIP™ 5162 Signal Processor User Manual Rev. 1
These notes include important information about the mounting, use, and maintenance of
this product. Read these notes before using the product.
· Always connect the product to a grounded circuit.
· Make sure the power cord is not crimped or damaged.
· Always disconnect the product from the power source before cleaning.
· Never disconnect the product from the power source by pulling or tugging on the cord.
· If mounting the product overhead, always secure it using a safety cable.
· Make sure there are no flammable materials close to the product when it is operating.
· Avoid direct eye exposure to the light source while the product is on.
· This product is not intended for permanent installation.
· The product is for indoor use only! It is rated at IP20.
· Do not expose the product to rain or moisture.
· Make sure that the voltage of the power source, to which the product is connected, is within the
range stated on the specifications label or on the rear panel of the product.
· Never connect the product to a dimmer or a rheostat.
· Always install the product in a location with adequate ventilation.
· Be sure that no ventilation slots on the product's housing are blocked.
· Do not operate the product in an ambient temperature higher than 104 °F (40 °C).
· In the event of a serious operating problem, stop using the product immediately.
· Never try to repair the product. Repairs carried out by untrained people can lead to damage or
malfunction.
· If repairs are required, contact the nearest authorized technical assistance center.
Keep this User Manual for future reference. If the product is sold to another user, this manual should
be included in the sale.
1. Before You Begin | Safety Notes
Page 11 of 140